This actually makes things easier as the remote receiver splits the lives so you only need one live input. Some fans have a remote control handset and receiver. If you only have a Switched Live and no permanent live then the Live from the fan AND the Live from the light will both need to connect to your switched live BUT this will mean than both the fan and light will only work when the wall switch is in the ON position.Įqually, if you only have a permanent live at ceiling level then you can connect both the Live from the fan and the live from the light to the permanent live and operate both independently on the pull cords on the fan itself Earth TO Earth (Ashes to Ashes, Dust to Dust)Įnsure the Earth is connected up, this is a safety feature and safety is most important.Neutral (Blue) TO Neutral (Black or Blue).Ceiling Fan Live (Brown) TO Permanent Live (Group of Red or Group of Brown).Light on Fan Live (Orange) TO Switched Live (Black with Red Sleeve or Brown with Blue Sleeve).The way we would recommend doing this is so that the ceiling fan is operational evening when the wall light switch is off (so you can use the fan at night with the light switched off at the wall). With all this new-found knowledge we can now wire the fan up to operate. This means that you can wire the fan to the permanent live and still have switch control. The more basic style of ceiling fan such as the one below has two pull switches. Below are the wires you can expect to see coming from a basic ceiling fan & Light. The Red wires are permanent live, the Black wires are neutral and the black wire with the red sleeve (left hand side) is the switched live (From the switch on the wall). ![]() If your house was rewired after 2004 then your wires may have been changed to the harmonized version (see the picture at the end of the blog). Bear in mind these are the older wiring colours. ![]() Now, once you have taken the old light fitting down you may well be presented with something like the below. This way you should be able to identify which wires are which. It’s fairly straightforward to replace a light fitting with a ceiling fan but we would always recommend taking a photo of the old light fitting wiring before removing the light fitting. It’s the same rule that covers replacing a 13amp plug socket. If you are replacing a light fitting with a ceiling fan then you are able (If you want to) to do this yourself. Always make sure the power is isolated at least 30 minutes before commencing any electrical work. ![]() All of the information offered in this blog is for information only, it should be taken only as a guide and Fantasia Dist Ltd cannot be held responsible for any loss or damage caused by using this guide. There are only certain things you are allowed to do yourselves and If you are not experienced or confident with electrical work then we would recommend getting a Part P registered electrician to do it for you. When it comes to electrics, safety is most important. Ok, so this has the potential to be the most boring blog in the history of the internet so we’ll try and keep it interesting.įirstly, the usual disclaimer.
0 Comments
Leave a Reply. |